Product Description

Blanket felt open width compactor for knit cotton fabrics

Machine characters

• Infra-red centering infeed device, correct the fabrics movement path automatically(shanghai brand)
• Equip weft correct adjusting roller, cooperate with the stenter frame pin plate, with a different speed to correct the fabrics weft.
• Pneumatic edge spreader(teeth spreader is optional) to flat the curled edges.
• Far infra-red auto edge detector and tracing system made in Shanghai, which can guarantee the fabrics pin on correctly, the width of the pin can be controlled in minimum.
• The wool brush wheel overfeed and pin on, right side and left side are driven by the separately motor, controlled by the inverter, overfeeding rate is -20%---+30%.
• The chain copies Hercules of Germany.
• The right and left stenting frames are driven by the separately motor, can movement with the little different speed, cooperate with the weft straighter to correct the weft.
• In front of the stenter frame and felt compacting unit, equip two steaming box made of stainless steel, the stenter frame steaming box equips air curtain in front side to block off the steam dissipation, which can guarantee the edge detector works normally(not disturb by the steam).
• Two pieces of thicken felt(20mm),the felt is used to compacting and setting, especially for open width fabrics,material is Du pont Nomex.
• Drying cylinder Heated byelectric thermal oil (steam is optional), intelligent control. Temperature tolerance is +_3
• The fabrics output by plaiting mode.
• Equip synchrocontrol devices, can harmonize the proportional speeds of each units automatically.
• Adjust the speed of the machine by inverter, HIM operation system. PLC programme controlled.

Machine structure

• Infeed device section
• Head of the machine section
• Cone-shaped stenter frame section
• Parallel stenter frame section
• Steaming box section
• Felt compacting units
• Cooling system section
• Plaiter section
• Pneumatic section
• Electric section