This machine is used before stenter and open width compactor. It can slit the tubular fabrics and then squeezing the water, immerse the softer, also it can squeeze water, immerse softner for the open width fabrics.
Rope fabrics infeed directly and be slit,automatic detwister (automatically cenering slitting line device is optional), this machine enhance the manufacturing efficient, omit the flow process. So can save time and labour, shorten the production cycle.
inverter gear reducer motor drive
0~80m/min(inverter control and adjustable)
Infeed and exit pattern
tubular infeed and open width exit
small padder before slitting machine 1.5Kw(optional)
padder 8.6 Kw
Tubular fabrics maximum width
slitter 3400mm 4000mm 6800 mm
padder 1200mmX3650mm 2200mm
small padder 2400mm 800mm 2000mm
- Turn table: Pull the fabrics trolley to the turn table, after fix it, the turn table will detwister automatically.
- Small padder(optional): The wet fabrics will be squeezed by the small padder,which can remove some water from the fabrics,which makes easier to slit,then the fabrics enter to the detwist device
- Detwister device: Rope type fabrics enter the detwister,there is sensor on the detwister, which can sense the twist and send signal to orer the detwister head and turn table to rotary and detwist, then fabrics will enter the slitting umbrella under the draw of the active motor.
- Slitting umbrella: It is made of stainless steel, diameter can be adjustable, there is synchronous breadth adjust device in the back. It is the same width with umbrella frame. When working, rotary the umbrella frame to center the slitting line(customer can order automatic slitting centering device)
- Slitting blade: Diameter 200 mm; rotary speed 2800rpm; when the three phase motor drive, it will start to slit the fabrics.
- Stretcher: After slit, the active roller will bring the fabrics to spreading frame, the stainless steel tube is made to triangle shape and will open the fabrics, it is flexible, can be adjusted. Then fabrics enter the padder through the infra-red centering device.
- Slat pattern infra-red centering device: Fabrics after slit go through double spreading shafts of the infra-red centering device to expand, then will be corrected by centering shaft, at last enter Padder.
- Though adjust the air cylinder, the different pressure will be press on the squeezing roller, then the extra liquid will be press out from the fabrics. The center of the squeezing roller is steel structure, outside covers USA special glue. Surface is high profile, the contact surface of the doule squeezing roller will have a parallel to the squeezing seam under 80KN pressure. There is liquor detention on the fabrics.
- Plaiting exit: Fabrics after squeezing liquid will exit with plaiting, it is drivin by active roller, driven by three phase motor.
- The electrical control adopts relay-contactor pattern, main driven speed is controlled by inverter.
- Electrical components, inverter is Delta brand, low voltage appliance is shneider of France.